R/C Stand designed to display your RIDE! Machined from 6061 aluminum Multiple angle positions Will support all R/Cs up to 1/8 scale size Can support 1/5 scale with 2 stands

Made in the USA Machined from billet aluminum Works with any r/c Awesome look Swivel base Adjustable height Converts from a floor to table unit Breaks down to smaller size

Made in the USA Machined from billet aluminum Works with any r/c Awesome look Swivel base Adjustable height Converts from a floor to table unit Breaks down to smaller size

Made in the USA Machined from billet 6061 aluminum Greatly reduces flex Machined pin brace for additional support Fits only 3906 Emaxx (1st version)

Made in the USA Machined from billet 6061 aluminum Single motor mount

Made in the USA CNC Machined from billet 6061 aluminum Increases strength to entire bulkhead section This bulk accepts current stock style diffs Diff case and bulk are machined into one unit Includes lower arm pin

Made in the USA CNC Machined from billet 6061 aluminum Increases strength to entire bulkhead section This bulk accepts current stock style diffs Diff case and bulk are machined into one unit Includes lower arm pin

This is the CNC machined E-Maxx transmission half-case from FastLane. It's made to house the G-Maxx single-speed conversion for the E-Maxx transmission.

Allows 3905 emaxx transmission to install into FLM Emaxx chassis. 

Made in the USA Machined from billet 6061 aluminum LCG (low center of gravity) design Complete kit Lightweight Adjustable battery system

Made in the USA Machined from billet 6061 aluminum Extended 35mm longer than stock 6mm thick chassis to reduce flex along with a 4 point chassis braces for the ultimate in strength Kit includes: chassis, 4 point braces, battery mounts, drive cups and heavy duty driveshaft Fits original 3906 Emaxx.

Made in the USA Machined out of billet 6061 aluminum 4 point chassis brace Front and Rear Driveshafts Multiple battery pack options Complete kit Fits 3905 E-maxx